I had been attempting to set up Trade 2010 requirements, when I came across some mistake. All look like the same. Like this one:
My server is operating Windows Machine 2008 L2 Standard Model.
Upgrade: I attempted installing the requirements one by one using PowerShell.Now I have got errors on RPC over Http proxy:
Error: Installation of Home windows Process Activation Service Configuration APIs been unsuccessful. the machine wants to become restarted to undo the changes.
My server is operating Windows Machine 2008 L2 Standard Model.
Upgrade: I attempted installing the requirements one by one using PowerShell.Now I have got errors on RPC over Http proxy:
Set up of Internet Machine (IIS) Doing a trace for Failed, Try to set up tracing hit a brick wall with mistake code 0x80070643. Fatal error during installation.
To start DHCP server installation, go to Start Menu, select Manage Your. You can set IP addresses of the WINS servers on the 'WINS Server' page if needed.
Searching about the mistake program code doesn'capital t inform me much more than something proceeded to go incorrect when attempting to upgrade windows.
Installing Http Looking up alone also doesn't make any difference.
Installing Http Looking up alone also doesn't make any difference.
Parsa
ParsaParsa
![Mise en place serveur winston salem Mise en place serveur winston salem](/uploads/1/2/4/8/124881746/534003812.jpg)
5 Solutions
Reinstall (all presuming this is an clear server, which it should be for exchange).
TomTomTomTom
Consider switching off UAC, rebooting amp; installing the pre-req'beds
iainlbciainlbc
I experienced this problem with an IIS function support install. I has been logged in as a domain name admin. When I ran machine supervisor 'as supervisor' it proved helpful fine.
consumer59188
I've you've moved the program TEMP files, try relocating them back again to the first C:WindowsTEMP
I've seen that result in the issue.
JimboJimbo
This error also happens when the server you are usually incorporating the function to will be using an IIS Shared Construction setup.
In this case it is usually enough to remove the Shared Construction, install the feature and then re-enable the Shared Configuration.
Joep GrootenJoep Grooten